dynamic unbalance

英 [daɪˈnæmɪk ˌʌnˈbæləns]

美 [daɪˈnæmɪk ˌʌnˈbæləns]

网络  动不平衡; 动态不平衡力; 动态不平衡; 动不平衡度; 动态失衡

计算机化学

双语例句

• Disturbance attenuation in turntable dynamic unbalance on the basis of multi-period finite-dimensional repetitive control
  基于多周期有限维重复控制的转台动不平衡扰动抑制
• So the paper puts forward a time domain integral algorithm of acceleration signal to eliminate the trend term and proves its effectiveness through simulation, which lays necessary foundation for the subsequent characteristics extraction of dynamic unbalance signal. 3.
  因此，论文在最小二乘拟合法的基础上，提出了消除趋势项的加速度信号时域积分算法，并通过仿真进行分析验证，为后续的动不平衡信号的特征提取奠定了必要的基础。
• Nonlinear Dynamic Behavior Analysis of Unbalance Response of Rotor-Bearings
  转子-轴承系统不平衡响应的非线性动力学特性分析
• The Development of New-type Vertical Dynamic Balancing Machine and the Measurement of Amount of Dynamic Unbalance of Work-piece
  新型立式动平衡机的研制与工件动不平衡量的测量
• Eliminating Heat Dynamic Unbalance of Axial Compressor on Site by the Method of Affecting Factor
  采用影响系数法现场消除轴流压缩机热态动不平衡
• Model Building and Multifactor Impact Analyzing for Dynamic Unbalance Quantity of Rotor V-milling Flute
  转子V型铣槽动不平衡量的计算建模及多因素影响分析
• The factors influencing dynamic unbalance of tool system for high speed cutting were analyzed. The ways to decrease the factors of dynamic unbalance were put forward, and determination principles about the accuracy class of dynamic balance of tool system for high speed cutting were described.
  分析了影响高速切削刀具系统动不平衡的因素，提出了减小不平衡因素影响的措施，重点论述了合理确定高速刀具系统动平衡精度的原则。
• It is easy to consider all Synchronous vibration due to various reasons as dynamic unbalance in plant practice, so that often to make erroneous diagnosis.
  工厂实践中极易将各种原因引起的同频振动均归结为转子不平衡，造成一些误诊。
• So, with the reciprocal mass of this combinational equipment, the dynamic unbalance of the Crank-connecting Rod Mechanism has the special status in the field of the unbalance theory.
  由于有往复质量的影响，曲柄连杆机构不可能达到完全的平衡，有其特殊性，因此其理论在动平衡领域内占有特殊地位。
• The three pads under the pedestal of the precision centrifuge is used for measuring the dynamic unbalance, one of them is mounted on a force-measuring sensor.
  在精密离心机机座下放置三个地脚，用一个测力传感器代替其中一个地脚。